Betekenis van:
pressure point

pressure point
Zelfstandig naamwoord
    • where problems or difficulties are likely to occur
    "a key pressure point in the controversy was the building permit"

    Hyperoniemen

    pressure point
    Zelfstandig naamwoord
      • an area on the skin that is highly sensitive to pressure
      "you must know the pressure points in order to administer shiatsu"

      Hyperoniemen

      pressure point
      Zelfstandig naamwoord
        • any of several points on the body where the pulse can be felt and where pressure on an underlying artery will control bleeding from that artery at a more distal point

        Hyperoniemen


        Voorbeeldzinnen

        1. When pressure is lower, the boiling point is lower.
        2. At a point, the pressure of a fluid is the same in all directions.
        3. After recording this equilibrium point, a higher pressure is set.
        4. Pressure cycle test set out in point (i) of Annex III.
        5. The thermometer thus reads the true boiling point, without errors due to superheating or hydrostatic pressure.
        6. of tyres near their point of contact with the ground and connections for tyre-pressure gauges;
        7. brake line pressure to brake pedal force, where permitted by point 7.2.5 or
        8. underground storage facilities connected to the high-pressure gas pipelines referred to in point (ii);
        9. In such cases the boiling point under reduced pressure may be estimated or measured, or
        10. of tyres near their point of contact with the ground, and of connections for tyre-pressure gauges;
        11. which has a melting point or initial melting point of 20 oC or less at a standard pressure of 101,3 kPa;
        12. In order to prove this, the container is exposed for a specified time to specified pressure and temperature conditions, and subsequently undergoes a burst test as referred to under point (a). The container must achieve a specified burst pressure.
        13. When determining the vapour pressure of low melting solids, care should be taken to prevent the condenser from blocking. After recording this equilibrium point, a higher pressure is set.
        14. Directive 97/23/EC contains in point 3.3 of Annex I detailed requirements on the marking and labelling of pressure equipment. This includes, for all pressure equipment, information on the essential maximum/minimum allowable limits.
        15. The pressure of the container is increased to a given value and a burst test as referred to under point (a) is carried out.